loadedtea3d
HomeTea Holders & DispensersFront-Pull Dispenser
Front-Pull Dispenser
Tea Holders & Dispensers

Front-Pull Dispenser

A front-pull gravity dispenser for loaded tea stick packets. Each column holds 15 packets, plus 1 standing up in the front display window so you can see what is inside. Pull a packet from the bottom tray and the next one drops down. The lid lifts off so you can refill from the top. The 4 slot and 6 slot slide into each other on built-in side rails, so you can mix sizes into a tea station. Printed to order in PLA in the colour you pick, body and lid in the same colour.

$284 Slot / Green
Size
1
  • Ships for $7, free over $60.
  • Free pickup: Within 15 miles, arranged after you order.
  • Local delivery within 15 miles for $5.

Holds

15 per column plus 1 on display

4 slot size

163 x 179 x 167 mm

6 slot size

240 x 179 x 167 mm (with rails)

Looking to buy Loaded Tea?

Stock up on packets for your dispenser at The Loaded Tea Shop.

Affiliate link: we may earn a small commission at no extra cost to you.

Shop Loaded Tea

More Tea Holders & Dispensers

Tilt Dispenser$20Tilt DispenserA tilt-out dispenser for loaded tea packets. One packet shows in the front window, and 13 to 16 more wait in the row behind it, depending on your packet size. Tilt the front open, take one, and it swings back. Pick a housing color and an insert color for each dispenser. Dispensers clip side by side and stack into a bank, and every insert fits every housing, so you can swap them around whenever you like.Customize
Carousel$35CarouselEight bays hold 40 loaded tea packets around a carousel that spins on its base. The center lid with its turning knob is included. Lift the carousel off the base to clean.Customize
Top-Grab Bin$18Top-Grab BinAn open-top bin for loaded tea stick packets. The packets stand upright in each slot and you grab one from the top. The front of every slot is cut low between two tabs, so you can see the label on the front packet and pinch it out.Customize

loadedtea3d is an independent maker of 3D printed loaded tea accessories. Not affiliated with any tea brand.